Pyronix Deltabell E G2

[Mark Hennessy]

I have existing Pyronix Deltabells on my installation and to maintain aesthetics I have purchased another one, although not for use with my alarm system, but to be triggered via an alternative source using a volt free normally open contact to act as a deterrent.

 

Noting this proposal, can someone advise how to wire the terminals and set the jumpers to activate the alarm (bell and strobe) when the external contact closes.

 

I have a separate 12v power supply for the install.

 

The manual for the wiring is here

 

Thanks in advance.

[MrHappy]

[Mark Hennessy]

19 hours ago, MrHappy said:

Many thanks for the prompt reply.

 

Would my external normally open contact go across the 'T' terminals?

 

I am using the onboard siren and strobe and have nothing else to connect.