Gardiner Technology PR2944

[Guest Andy W]

Hi all, can anyone help?

A friend of mine has just taken over the lease on a shop and there is a Gardiner Technology PR2944 Rev2.0 panel installed, the problem been no one knows the code so it can be used again. Some one has had a tamper and obviously the alarm activated once the lid of the panel was removed and they disconnected the battery and the mains power supply to silence it, the bell box outside still alarmed as it must have a back up battery, this sounded for about 10 mins then silenced it self. What we need to do is to programme in a new code so any set up manuals that you may have available I would appreciate. I have no idea how old the system is and my friend can not afford to call out an alarm engineer. If we can not do what we need to do I shall install a second hand Veritas 8 that I have knocking about as I am familiar wit them. Any help appreciated.

[Guest]

unfortunatly we are unable to post defaulting information or supply manuals if you are not a trade member

if you post your location an engineer from this site, in your area MAY be able to help you

regards

glen

[Guest Andy W]

unfortunatly we are unable to post defaulting information or supply manuals if you are not a trade member 

if you post your location an engineer from this site, in your area MAY be able to help you 

regards

glen 

48984[/snapback]

Never mind, I am not an alarm engineer by trade just a self employed engineer & 16th edition electrician trying to do a friend a favour, looks like I will just rip it out and bin it and replace with the Veritas system that I have installed plenty of and have all the relevant information on, thanks anyway.

[Guest]

sorry about that but this is a security forum

the information you are asking for is only available to the trade

regards

glen