Guest dcaer Posted November 14, 2005 Posted November 14, 2005 Gents, I have an accord xpc panel installed by a large company and following a upgrade to asdl the keypab shows a flashing telephone symbol (Comm failure) So as company said I needed to install a filter I purchase a Excelsus Z-A431EU alarm panel filter for ASDL. Installed as per instructions , following a visit from engineer from large company symbol still showing . Alarm activated OK but did not restore. During night phone bill shows 10 calls to alarm center all answered. Question is there a fault with panel modem or is handshake from alarm center the problem with panel.
Nova-Security Posted November 14, 2005 Posted November 14, 2005 Digi not getting the handshake due to ASDL carrier signal, you need to check the filter sounds like it could be installed wrong. www.nova-security.co.uk www.nsiapproved.co.uk No PMs please unless i know you or you are using this board with your proper name.
norman Posted November 15, 2005 Posted November 15, 2005 The filter is installed inside the Xpc isn't it? Nothing is foolproof to a sufficiently talented fool.
engineery Posted November 16, 2005 Posted November 16, 2005 who do you pay for your phone calls, is it tiscali? Any comments / opinions posted are my opinion only and do not represent those of my employer or Company
Guest Guest Posted November 16, 2005 Posted November 16, 2005 who do you pay for your phone calls, is it tiscali? I pay every day , panel defective thanks folks for advise and assist . filter installed in panel.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.